LaserJet 2100/2200 Fuser Installation
|
|
|
LaserJet
2100/2200 Series Fuser Installation
Instructions |
| |
Models:
2100|2100m|2100se|2100n 2100xi|2100tn | 2200
| 2200d
2200dt | 2200dse | 2200dtn
NOTE: These instructions are simply
a guide. First Choice assumes no responsibility or
liability for any damages caused by user while working
on there printer during this repair. |
|
|
|
Tools Required |
•
#
2 phillips screwdriver
|
|
|
| Step
1 |
Begin by facing the rear of the printer
and Identifying the fuser cover. |
|
|
| Step
2 |
Remove the two screws,
holding the cover plate on. |
|
|
| Step
3 |
Gently remove the cover plate working
it from top to bottom. Be careful not to damage
this plate there are plastic sensors attached. |
|
|
| Step
4 |
After
the cover plate is off identify and remove the fuser
screw located on the left. (See picture) |
|
|
| Step
5 |
Remove
fuser wiring as seen in picture there will be three
connectors total. |
|
|
| Step
6 |
Simply
slide the fuser outward, your done. |
|
|
