LaserJet 4/4 Plus/5 Lid Removal
|
|
|
LaserJet
4/4 Plus/5 Series Lid Removal
Installation Instructions |
| |
Models:
4 | 4m | 4 Plus | 4m Plus | 5
| 5m | 5n
NOTE: These instructions are simply
a guide. First Choice assumes no responsibility or
liability for any damages caused by user while working
on there printer during this repair. |
|
|
|
Tools Required |
•
#2 Phillips Screwdriver
• Small Flat Blade Screwdriver |
|
|
| Step
1 |
Lift toner cartridge door open and remove the one
screw located on the upper right side |
|
|
| Step
2 |
Remove the accessory
cover plate on the right , you will need to open
the rear exit door of the printer to do this. |
|
|
| Step
3 |
Turn the printer around so you are
now facing the rear of the printer, once again now
open the rear exit cover to expose the lid screws. |
|
|
| Step
4 |
Remove
the top right lid screw. |
|
|
| Step
5 |
Remove
the top left lid screw. |
|
|
| Step
6 |
Once
again turn the printer around so you are facing
the front of the printer, take your flat blade screw
driver and depress the right lock while lifting
the cover upwards. |
|
|
| Step
7 |
Repeat
this procedure on the left side, while applying
upward lift of the printers cover these two clips
are what hold the plastic lid down.
|
|
|
| Step
8 |
Do
not remove the lid all the way until you remove
the printers display wiring harness there will be
only one plug in and it is located on the display
after you have removed it you can rest the cable
any were until you re-connect the display. |
|
|
