LaserJet 1000/1150/1200/1300 Pick-Up Roller & Separation Pad Installation
|
|
|
LaserJet
1000/1150/1200/1300 Series Pick-Up Roller & Separation
Pad Installation Instructions |
| |
Models:
1000 | 1150 | 1200 | 1200n | 1220|1300 | 1300xi |
1300n
NOTE: These instructions are simply
a guide. First Choice assumes no responsibility or
liability for any damages caused by user while working
on there printer during this repair. |
|
|
|
Tools Required |
Flat
blade screw driver |
|
|
| Step
1 |
Remove Toner & Paper Tray. Remove the Paper
Tray by first removing the Upper Tray Cover and
then the Lower Tray can be removed by lifting up
and out.
NOTE: Do not force the Lower Tray,
you can break the plastic. |
|
|
| Step
2 |
Paper Tray removed |
|
|
| Step
3 |
Open the Toner Access Door and you
will be able to identify the Feed Roller. |
|
|
| Step
4 |
Remove
the Feed Roller by expanding the Left & Right
White Clips located at the top outward. At the same
time roll the Roller toward yourself. The Roller
will simply slide out of it's socket. |
|
|
| Step
5 |
Remove
the Separation Pad by sliding a small Flat Blade
under it and pry gently, it will snap out of it's
socket. |
|
|
| Step
6 |
Here
we show a upside down view of the Separation Pad
to show the Clips. |
|
|
| Step
7 |
Be
sure to align the 
Separation
Pad correctly, and then apply some downward pressure
and the Separation Pad will lock in to place. |
|
|
| Step
8 |
Reinstalling
the
Feed Roller simply start by aligning the bottom
of the
Roller
in to the Hinges, you will notice that the bottom
of the Roller has Round Nipples were the top is
Square, the Round goes on the bottom and simply
roll the Roller upwards until it locks in to place. |
|
|
