LaserJet 4/4 Plus/5 Series Pick-Up Rollers
|
|
|
|
LaserJet
4/4 Plus/5 Series Pick-Up Rollers &
Separation Pad Installation Instructions
|
| |
Models:
4 | 4m | 4 Plus | 4m Plus |
5
| 5m | 5n
NOTE: These instructions are simply
a guide. First Choice assumes no responsibility or
liability for any damages caused by user while working
on there printer during this repair. |
|
|
|
Tools Required |
Small Flat Blade Screwdriver |
|
|
|
Step 1
|
|
Remove the Tray 1 or (MP Tray) Cover Plate, this
can be accomplished by pinching the top center of
the Plastic Black Cover and pulling toward yourself.
|
|
|
|
|
Step
2
|
Identify and remove the Tray 1 Roller, simply pinch the Lock
Clip while you slide the Roller to the right off
the Shaft.
|
|
|
|
|
Step
3
|
Identify the Small Separation Pad and remove it
by sliding a Small Flat Blade Screwdriver under
it and gently pry upwards, the Pad will come off.
When reinstalling your 
Separation
Pad simply rest the Pad on top of the Pad holder
and push down it will snap in to place. (Be Gentle)
|
|
|
|
|
Step
4
|
Remove
the Paper Tray for installing the Tray 2 Paper Pick-Up
Roller. Identify the Tray 2 Pick-Up Roller, you
may have to angle your Printer up a little in the
front to see clearly, simply look up and in on the
left and you will see the Roller, simply pinch and
slide the Roller to the right for removal. When
reinstalling your
Roller simply push the Roller on the Shaft, you
may have to rotate the Roller until it snaps into
place.
|
|
|
